Hardware update

[DollarBill]

It seems to be working, though I haven't pushed it with a ton of modules to see if the sound is as clean as the advertising says it can be - oonly variable is if the power brick I got has enough amps when the case is full. So finally after ordering this in Novermber, I have capacity to grow again.

Also, a new module being tested.

[Ashley]

I really dig this, sound quality is amazing too, also did you do some panning L/R, it sounds like a great stereo mix!

[Heigen5]

Yeah, the sound has a nice stereo-field, does it come from the delay/reverb or is the sound stereo already from the beginning?
Congrats on for getting new toys! Did they cost a lot?

[DollarBill]

Thanks guys.

The panning is an integral part of the sound - it draws a shape with a tiny dot (if you lower the pitch far enough, you can see it moving instead of the solid lines you see), and the dot height vs center goes out one output, while the left-right position of the dot goes out the other. The faster the dot moves, the higher the pitch just like any other oscillator. So if you have it drawing a perfect circle, it basically puts out a plain sine wave, no L/R info, but the weirder the shape the wider the sound. The hint of delay/reverb is also stereo, but I only added a touch so it wouldn't be so raw.

I got the module used, made an offer under the Reverb site price, so it wasn't as bad as new, but the power for the case was expensive - cost more than the case itself (which already had power in it). Small modular systems can be affordable, but all the little pieces do add up.

[DollarBill]

Here's a little more Polygogo action, not going crazy with modulation and stuff here, just trying something more subtle.

[Heigen5]

Very interesting sounds in this.

[Ashley]

Are you noodling on the noodle machine again? haha. Another great modular vid, well done! thanks for sharing $bill!!